Nordson Encore LT, Product Manual, Page: 43 / 92

Operation
4-9
Part 1604857-04
E 2014 Nordson Corporation
Tube Bracket
Pickup Tube
Pickup Tube Arm
Figure 4-6 Pickup Tube Bracket Use
2. Place a box of powder on the vibrator table.
3. Fold back the box flaps and open the plastic bag containing the powder
coating. Fold the bag over the box flaps to keep the flaps out of the way.
NOTE: Do not force the end of the pickup tube into the powder. Vibration
and gravity will cause the pickup tube to sink into the powder.
4. Swing the tube bracket out from under the pickup tube and slide the
tube down into the powder.
5. To prevent accidental powder spills, wrap the plastic bag around the
pickup tube and loosely secure the bag with a tie wrap.
Vibratory Box Feeder Operation
When the controller is configured for a vibratory feed system, the vibratory
box feeder relay control is enabled. The relay turns on the vibrator motor
when the spray gun is triggered.
When the spray gun is triggered off, the vibrator motor remains on for a
configurable delay. This delay prevents rapid on/off motor cycling every time
you trigger the gun off and on and prolongs the life of the motor. The default
delay time is 30 seconds.
The vibrator motor can also be set to continuous operation. If set this way,
press and release the spray gun trigger to start the motor. To turn off the
motor, press the Enable/Disable button or turn off controller power.
To configure the system for a vibratory box feeder, change the VBF delay
time, or set the vibrator motor to continuous operation, refer to page 3-16.