System Overview
2-7
Part 1603054-02
E
2015 Nordson Corporation
HDLV Pump and Spray Gun Pattern Air Quality
Air must be clean and dry. Use a regenerative desiccant or refrigerated air
dryer capable of producing a 3.4
o
C (38
o
F) or lower dew point at 7 bar
(100 psi) and a filter system with pre-filters and coalescent type filters
capable of removing oil, water and dirt in the submicron range.
Recommended Air Filter Screen Size:
5 micron or smaller
Maximum Oil Vapor in Air Supply:
0.1 ppm
Maximum Water Vapor in Air Supply:
0.48 grains/ft
3
Moist or contaminated air can cause the HDLV pumps to malfunction; the
powder to cake in the reclaim system, or clog the feed tubing, and spray
gun powder paths.
Special Conditions for Safe Use
Caution should be taken when cleaning plastic surfaces of the iControl.
There is a potential for static electricity build up on these components.
The Encore HD Powder Electrostatic Automatic Applicators shall only be
used with the associated Encore HD iControl Controllers over the ambient
temperature range of +15
_
C to +40
_
C (59
_
F to 104
_
F).
Approvals
See Figure 2-4 for the approval labels affixed to the equipment.
Obsolete
Summary of Contents for Encore HD iControl System
