Nordson Encore HD iControl System, Hardware Manual

Page: 35 / 93

Installation
3-13
Part 1603054-02
E 2015 Nordson Corporation
NOTE: If using a single horizontal scanner, the controller must be
programmed to ignore the conveyor. This requires software from the
scanner manufacturer, a laptop running Windows, and a serial cable to
connect the laptop to the scanner controller in the junction box.
BSCE − L
BSCR − L
BSCE − R
BSCR − R
Dual Positioner Scanner Configuration
PEJB
Positioner
Scanner J-Box
SCNR1
SCNR1
Ethernet
BSCE
BSCR
PEJB
Positioner
Scanner J-Box
SCNR1 SCNR1
Ethernet
Single Positioner Scanner Configuration
Figure 3-7 In/Out Positioner and Reciprocator Analog Scanner Connections
Customer-Supplied Part ID System Connections
Refer to Table 3-2. Use the Part ID terminals on the PEJB to connect a
customer-supplied part ID system to the iControl console. The 8 inputs are
used based on the settings made in the Photoeye Configuration screen.
Refer to the iControl Operator Interface manual for configuration
instructions.
Ethernet Network/Gun Mover Control
The Ethernet network allows the iControl system to communicate with the
gun mover PLCs and the analog scanner controllers through a network
switch. The PLCs control the Variable Frequency Drives (VFDs) that power
and control the gun mover motors according to the settings made in the
iControl software.
Oscillators are not controlled by the iControl software. The PLCs control
their motion during color changes only.
Obsolete