Nordson Encore HD iControl System, Hardware Manual

Page: 38 / 93

Installation
3-16
Part 1603054-02
E 2015 Nordson Corporation
Program and User Data Cards
The iControl program and configuration data is stored on the Compact
Flash program card. All user data and preset settings are stored on the
CompactFlash data card. These cards function as removable hard drives.
The iControl consoles are shipped with these cards installed. Refer to the
Parts section for program and data card kits.
CAUTION: The Compact Flash cards CANNOT be hot-swapped. Shut
down the iControl program and operating system, then turn off the iControl
console before removing the cards. Removing the cards while power is on
could corrupt the data on the cards and damage the cards.
CAUTION: Never turn off console power without first shutting down the
iControl program and operating system. Doing so could corrupt the system
software. Refer to Program Shutdown in the iControl Operator Interface
manual for the shutdown procedure.
See Figure 3-10. The CompactFlash card slots are on the back on the PC.
The top card (1) is the data card; the bottom card (2) is the program card.
NOTE: To remove a card, simply pull it out of the slot.
1
2
Figure 3-10 User Data and Program Card Locations
1. Data card
2. Program card
The iControl program can be updated by installing a new program card.
In addition to the configuration data, up to 255 presets per gun can be
stored on each data card. To copy a data card to a blank card, use the Data
Backup function. Refer to Data Backup in the iControl Operator Interface
manual for instructions.
NOTE: Not all CompactFlash cards are the same. For approved cards,
order the cards listed in the parts section, or contact your Nordson controls
engineer or Nordson Technical Support.
Obsolete