NorAM 65E Turbo, Operator'S Manual

Page: 97 / 118

NORAM 65ET GRADER
3-35
Lubrication and Maintenacne
3
Operation 49 - Moldboard Cutting Edge
Cutting edges and end bits should be replaced when worn or damaged. End bits are interchangeable from left to right.
Cutting edges are interchangeable from left to right.
WARNING:
NEVER WORK UNDER RAISED EQUIPMENT. USE BLOCKS TO PREVENT IMPLEMENT
OR MOLDBOARD FROM DROPPING.
1. Raise moldboard. Place suitable blocks or stands under the
circle. Lower circle so it rests on blocks.
2. Remove nuts, 1, and bolts attaching cutting edge, 2, or end bits,
3, to moldboard.
3. Remove any mud or debris from moldboard contact surfaces. If
edge is to be reversed, clean mounting surfaces of cutting edge.
4. Attach cutting edge to moldboard. Secure with countersink
carriage bolts.
Operation 50 - Moldboard Guides
Moldboard guide clearance must be checked to prevent looseness
and excessive wear of the moldboard guides. Remove shims, 1,
until clearance is 0.76 - 1.52 mm (0.030 -0.060 in.). Torque bolts
to 945-1215N x m (700-900 lb-ft).