NorAM 65E Turbo, Operator'S Manual

Page: 64 / 118

1
NORAM 65ET GRADER
3-2
Lubrication and Maintenance
3
ADDING FUEL CONTINUED - To add fuel to the machine, open access door on the right side of the engine cover.
Clean area around fuel cap. Remove cap, 1, and place in a clean area during refueling. After filling tank, replace and
tighten fuel cap. The Cummins engine is shown in the left picture and the Cat engine is shown in the right picture.
CUMMINS ENGINE CAT ENGINE
ELECTRIC MASTER SWITCH
Inside the right side engine access door is a master switch, 1. When in the "off" (vertical) position the ground circuit to
batteries is opened. Turn switch off and remove key when the machine will be parked for long time periods or while
servicing. To operate machine, turn master switch "on". Cummins engine is shown on the left and Cat engine is shown
on the right.
CUMMINS ENGINE CAT ENGINE
CAUTION:
FAILURE TO TURN MASTER SWITCH OFF MAY RESULT IN ELECTRICAL SHOCK OR
DAMAGE TO MACHINE COMPONENTS.
SERVICE INTERVALS
The recommended intervals listed on the chart should be adjusted when operating in severe conditions. Time intervals
should be checked when the machine reaches either the number of hours or the time allotment, whichever comes first.
As an example, if the motor grader has accumulated 1200 hours and a year has passed since hydraulic oil was replaced,
change the hydraulic oil now rather than waiting until 2000 hours have passed.
PREVENTING CONTAMINATION
To prevent contamination when changing oils, filters, etc., always clean the area around the filler caps, level plugs,
drain plugs, dipsticks and filters prior to removal. To prevent dirt entry during greasing, wipe dirt from the grease
fittings before attaching grease gun. All grease fittings are equipped with caps which must be removed before attaching
grease gun. Reinstall cap after wiping off excess grease to prevent dirt entry.
1
1
1
1