NorAM 65E Turbo, Operator'S Manual

Page: 7 / 118

NORAM 65ET GRADER
0-3
S
afe
ty
0
9. Install lock pins in front and rear mounted
implements before transporting machine between
job sites.
10. Do not park on a steep incline.
11. Do not operate the vehicle in an enclosed building
without adequate ventilation. Exhaust fumes can
cause death.
12. If the power steering or engine ceases to operate,
stop the vehicle immediately.
13. Stop the engine and relieve pressure before
connecting or disconnecting hydraulic, steering or
fuel lines.
14. Tighten all connections before starting engine or
pressurizing lines.
15. Remember that the vehicle, if abused or
incorrectly used, can be dangerous and become a
hazard to the operator and bystanders.
16. Noise levels can exceed recommended levels when
working between buildings or in confined areas on
canopy equipped machines or cab equipped
machines with doors and windows open. Use ear
protection when warranted.
17. Always look in the direction of travel when
moving the machine. Be sure personnel in the area
are clear before moving the machine or implements.
If someone arrives in the operating area, stop the
machine immediately.
18. When transporting or travelling on roads,
position moldboard within width of machine.
19. When driving on roads have consideration for
other road users. Pull to the side of the road so
following traffic may pass. Maintain a safe distance
from other vehicles. Yield right of way to loaded
machines.
20. Obey federal, state and local laws concerning
slow-moving emblems, flashers, rotating beacons
and licensing requirements.
21. Obey flagmen, safety signals and signs.
22. Dim vehicle lights when meeting a vehicle at
night. Make sure lights are adjusted to prevent
blinding oncoming drivers.
23. Reduce speed before turning or applying brakes.
24. Use extreme caution and avoid hard application
of brakes when towing.
25. Always check overhead clearance, especially
when transporting. Be aware of low, overhanging
obstacles, such as trees and bridges.
26. Know the exact location of gas lines, utility lines,
sewers, overhead and buried power lines and other
obstructions before operating in an area.
27. Use a signal person in congested areas or when
people are around.
28. Use extreme caution when operating on slopes.
Avoid traveling across slopes. Drive up and down
slopes whenever possible.
29. If slopes cannot be avoided, keep moldboard low
and close to the machine. If machine starts to slip,
lower moldboard to the ground.
30. To avoid overturns, drive the vehicle with care
and at speeds compatible with safety, especially when
operating over rough ground, when crossing ditches
or slopes and when turning.
31. Select the same gear when going downhill as you
would going uphill. Select the gear before starting
down the slope.
32. Do not coast or freewheel machine down hills or
slopes.
SERVICING
1. Do not allow unauthorized personnel to service or
maintain this machine. Do not perform any work
that is not authorized.
2. Machine should not be serviced with anyone in the
operator's seat unless that person is qualified and is
assisting in the service procedure. Be sure operator
can see mechanic.