NorAM 65E Turbo, Operator'S Manual

Page: 40 / 118

1
NORAM 65ET GRADER
2-6
Op
era
tion
2
Headlights and Taillights
Headlights are mounted on front of the motor grader above the
front wheels. Taillights are mounted on the rear of the machine.
The headlights and taillights are controlled by the multi-function
switch on the left side of the front console.
To activate the taillights, turn the end, 1, of the multi-function
switch one notch counterclockwise. To activate the taillights and
headlights, turn the end of the switch fully counterclockwise (two
notches). To turn off headlights and taillights, turn end of the
multi-function switch fully clockwise.
High beam is activated by pushing the switch forward, 2. To
return to low beam, pull the switch rearward, 3, and release. To flash the high beam, pull the switch rearward and
hold. High beam will be activated until the switch is released.
Turn Signals
Turn signals and flasher lamps are mounted at the front and rear of the machine, alongside the headlights and
taillights. They provide visibility and information to other drivers.
To activate turn signals, move multi-function switch up, 4, to signal a right turn or down, 5, to signal a left turn.
When the turn has been completed, move multi-function switch to center position.
NOTE:
Multi-function switch does not automatically return to "off" position after turning.
Horn
The horn is used to signal others of impending movement or operation of the grader. To activate the horn, push end of
multi-function switch in, 6, toward the front console.
Hazard Lights
Hazard Lights, located at the front and rear of the machine, are
activated by a switch, 1, on the top of the front console. Use the
flashers whenever the motor grader is travelling along the road.
Press the top of the switch to activate the flashers and the bottom
to deactivate the flashers.
NOTE:
Follow federal, state and local laws regarding road
travel of slow-moving vehicles and construction equipment.
1