Nokia IP560 - Hard Disk Drive Based, Installation Manual

Page: 131 / 160

Replacing a Nokia Encryption Accelerator Card
IP560 Security Platform Installation Guide 131
Use Nokia Network Voyager to configure your software applications (IPSec
or Check Point VPN) to make use of the available hardware accelerator. For
information about how to configure software applications, see
“Configuring
Software to Use Hardware Acceleration” on page 137.
This section describes how to replace a previously installed accelerator card.
Before You Begin
To replace the accelerator card, you need:
„
Physical access to the appliance
„
The Nokia encryption accelerator card and installation kit
„
Phillips-head screwdriver
„
Four screws (included in kit)
„
Grounding wrist strap (included in kit)
Caution
To help guard against electrostatic discharge damage, make sure
you are properly grounded by using a grounding wrist strap and
following the instructions provided with the wrist strap before you
handle the components or open the appliance.
Note
You do not need to manually disconnect power for this procedure. If the
power supply switch at the rear of the appliance is difficult to reach, you
can safely disconnect power when you remove the chassis tray assembly
from the front of the appliance. Any servicing of the appliance should be
completed with the chassis tray assembly fully removed from the
appliance.