Nokia IP560 - Hard Disk Drive Based, Installation Manual

Page: 49 / 160

Performing the Initial Configuration
IP560 Security Platform Installation Guide 49
„
The chassis tray assembly is pushed all the way in from the front of the
appliance.
„
That power is turned on to the power strip or wall receptacle into which
you plugged the appliance.
If the fans are still not running, or if the power LED does not illuminate,
contact your Nokia service provider or Nokia Support as listed in
“Nokia
Contact Information” on page 3 for technical support.
Performing the Initial Configuration
If you do not use DHCP to perform the initial configuration of your Nokia
IP560 security platform, you must use a serial console connection (cable
included). After you perform the initial configuration, you no longer need the
console connection.
To perform the initial configuration
1.
Turn on the appliance.
At the console a series of startup messages appears, then the following
prompt appears:
Type any character to enter command mode.
The prompt remains on the screen for about five seconds.
Note
For information about how to use the boot manager, see Chapter 6,
“Using the Boot Manager.”
After some miscellaneous output appears, the following prompt appears:
Hostname?
If the Hostname? prompt does not appear on the console, check the
console port and console display connections to ensure that the serial
cable is completely plugged in at both ends. If you verify the console