BEFORE OPERATION
1-11
1.5 Installing the Label Roll
1.5.1
Installing the label roll
This section explains the procedure for installing the label roll.
1
Press the power switch to turn
off the printer.
The POWER light goes off and the power
shuts off.
2
Open the top cover.
Press the left and right triangle marks on the
top cover to unlock and open the cover.
3
Pull the print head locking lever
toward you and then raise the
arm unit.
4
Specify the label width.
Squeeze the label holder tabs to release
them. Then slide the tabs to the correct
position, depending on the label width.
Refer to the scale to find the correct position.
5
Check the platen roller.
For backing paper less than 63 mm wide, use
a narrow platen roller.
To replace the platen roller, refer to “Section
4.3 Replacing the Platen Roller”.
Open the top cover
gently. Opening the
cover abruptly or
extending it beyond 90
degrees to the plane of
the printer itself may
cause the cover to
come loose and fall.
This unit operates with
label rolls which
“unwind”, that is, the
labels face toward the
spindle rather than
toward the outside.
Be sure to turn off the
power. Not doing so
may result in personal
injury or an equipment
malfunction.
Summary of Contents for DURA PRINTER SL
