9
– English
EN
6.
B -
Adjustment of “Sun” climate sensor
At the factory, the intervention threshold to is set at level 3 and to change it you must take the following steps:
01.
Keep the
n
key pressed and wait for the motor to perform 2 movements. Upon completion, release the key.
02.
Keep the
t
key pressed and wait for the motor to perform 3 movements. Upon completion, release the key.
03.
Briefly press the
t
key a few times, depending on the level you want to set for the intervention threshold:
1 press
= 5 Klux
2 presses
= 10 Klux
3 presses
= 15 Klux (factory setting)
*
4 presses
= 30 Klux
5 presses
= 45 Klux
After about 10 seconds, the motor performs the number of movements indicated by the level number selected.
Note
– If this does not occur, cancel the proce-
dure. this way, the adjustment is completed without changing the factory setting.
04.
Keep the
n
key pressed and wait for the motor to perform 3 movements. Upon completion, release the key.
1
/
2
/
3
/
4
/
5
/
10
sec.
03
0,5
sec.
x 1
= 5 Klux
x 2
= 10 Klux
x 3
= 15 Klux (
*
)
x 4
= 30 Klux
x 5
= 45 Klux
5
sec.
01
02
5
sec.
04
5
sec.
3
2
?
3
Note
: • When performing the procedure, you can cancel it at any time by keeping the
n
and
t
keys pressed simultaneously for 4 seconds. Otherwise, do not press
any key and wait 60 seconds for the motor to perform 6 movements. • If you use a sensor equipped with a “trimmer”, you must read the sensor instructions and ad
-
just the threshold directly on the sensor.
6
.A -
Programming the desired command (“Open” or “Step-by step”) for the
button on a keypad
After connecting a
keypad with 1 button
, follow the procedure below to assign the desired command to the button:
Open
or
Step-by-step
. Use a transmitter mem-
orised in “Mode I” to perform the procedure.
01.
Keep the
n
key pressed and wait for the motor to perform 2 movements. Upon completion, release the key.
02.
Keep the
s
key pressed and wait for the motor to perform 3 movements. Upon completion, release the key.
03.
Keep the
n
key pressed and wait for the motor to perform 3 movements. Upon completion, release the key.
04.
Keep the
n
key pressed and wait for the motor to perform 2 movements. Upon completion, release the key.
05.
•
To assign the Open command to a pushbutton:
Keep the
s
key pressed and wait for the motor to perform 3 movements. Upon completion, release the key.
•
To assign the Step-By-Step command to a pushbutton:
Keep the
t
key pressed and wait for the motor to perform 5 movements. Upon completion, re-
lease the key.
04
05
05
5
sec.
5
sec.
5
sec.
Open
command
Step by
step
command
5
sec.
01
03
02
5
sec.
5
sec.
2
3
2
3
3
5
Note
– When performing the procedure, you can cancel it at any time by keeping the
n
and
t
keys pressed simultaneously for 4 seconds. Otherwise, do not press
any key and wait 60 seconds for the motor to perform 6 movements.
