49
Display defi ni ons and troubleshoo ng guide.
Displayed on
screen.
Defi ni on.
Solu on.
In normal opera ng mode.
rdy
Unit is standing by and ready for next instruc on.
Trigger to run a required rou ne.
ac
Charger powered down due to Vac mains
interup on.
Check 220VAC or 29Vac supply to the unit.
Check 500mA fast blow fuse in the 220Vac connector.
Bat
Ba ery is either disconnected or discharged.
Check the 10A fuse in the ba ery lead.
Allow 8-10 hours uninterrupted charge before trying to operate the unit
again. If the ba ery has not recovered a er this, then replace the ba ery.
rel
Gearbox manual release is in released (Manual)
posi on.
Lower the release lever to engage gearbox.
Test manual release lever reed switch.
Check that the manual release lever magnet has not been dislodged.
irb
Infra-red beams circuit is being triggered.
Remove obstruc on from the path of the safety beams.
Check that beams are powered and func oning properly. Ensure the safety
beam circuit end of line resistor has been installed properly as per this
manual.
Hol
Control card is in Holiday Lock-out mode.
Follow the steps on page 42 to deac vate Holiday Lock-out.
par
Control card is in Party mode.
Follow the steps on page 43 to deac vate Party mode.
col
Mul ple collision lock-out ac ve.
See page 32 and “Selec ng a safety level” on page 20.
for
Safety overload triggered by physical overload.
See page 32 and “Selec ng a safety level” on page 20.
ref
Referencing the gate closed posi on.
See “Referencing the closed posi on” on page 10.
e-l
Failure to see the closed limit.
See Installing the limit actuator on page 16.
opn
Gate is open.
Trigger gate to close.
pr9
Control card is in Programming mode.
Press and release X to exit programming mode.
e1
Revolu on counter/encoder failure.
Ensure control card is fastened down correctly and that the ring magnet is
installed correctly in place atop the motor sha .
e3
Motor is disconnected, motor fuse is fused or
electric motor is faulty.
Ensure the motor is connected correctly. Test the 10A motor fuse. Test the
electric motor by disconnec ng it from the control card and running it on a
ba ery directly.
In programming mode.
abt
Procedure aborted via the “X” bu on.
Begin the procedure again.
dne
Procedure completed.
Con nue on to another programming op on or exit programming.
e-l
Closed limit not installed correctly.
See Installing the limit actuator on page 16.
for
While buzzer beeps 20 mes. Excessive gate
resistance.
Repair gate rolling load, so that it remains below the rated load specifi ed
on page 4.
ful
Receiver memory is full.
Delete any user addresses no longer in use.
to
Time out error while programming a remote.
Begin transmi ng with the remote before pressing set. Remote maybe
damaged or faulty. Ensure the remote does indeed transmit.
dec
Decoding error.
The remote does not use a format that is compa ble with the receiver.
