21
Selec ng a BT opera ng mode and adjus ng the BT auto-close me.
bt
From Ready status
rdy
The factory default is standard 3 step mode.
The factory default auto-close me is 15 seconds. The mer range is
1 – 254 seconds. PLEASE NOTE!! A set of safety infra-red beams must
be installed using the technique indicated in this manual before se-
lec ng any of the auto-close modes. If “irb” mode has not been con-
fi gured then the auto-close modes are blanked out of programming
and not available. The safety beam func on on this control card con-
forms to the CE safety standards.
Ac on
Response
Descrip on
Display
Buzzer
Gate
To enter the program menu.
Press and hold the
bu on
un l buzzer beeps.
Display and buzzer
confi rms.
pr9
Scroll < or > to select the bt
setup op on.
Display scrolls
through op ons.
bt
With “bt” on the display,
press and release
.
Display shows current
op on status.
5td
Scroll < or > to the required
BT mode op on.
Display changes
respec vely.
5td
aut
con
pir
p-c
With required se ng
displayed, press and release
.
If Standard mode was
selected, the display
and buzzer will
confi rm the se ng
is saved. Display
then reverts to
programming op ons
list.
bt
If Auto-close, CONDO,
P.I.R.A.C. or P.I.R.A.C.+
CONDO were
selected, then the
display prompts you
to select the required
auto-close me.
015
Scroll < or > to the required
se ng.
Display changes
respec vely.
010
With required se ng
displayed, press and release
.
Display briefl y shows
the new se ng is
saved.
010
A er display confi rms new
se ng.
010
Display returns to
programming menu
op ons list.
bt
Scroll le or right to next
program op on.
OR
rdy
EXIT back to standby
status
