Nice Apollo 4300SW, Manual

Page: 19 / 46

17
Learn
Enter
“Enter” Flashes
Figure 10 - LCD DISPLAY
5
6
3
1
2
4
7
Figure 12 -Open Learning
11 - INSTALLATION PROCEDURES (CONT.) 12 - INCOMING POWER WIRING
Power input connections should be wired as follows:
Battery
Connect wires to the battery terminal block. The positive
wire of the battery connects to the left terminal marked “+”.
Note: If the battery is connected backwards a red LED will
illuminate below the terminal.
Main DC Power - This terminal block is for incoming
10-32VDC power only!
Connect wires to the main DC power terminal block. Positive
of the power supply connects to the left terminal marked “+”.
Note:
If supply is connected backwards a red LED will
illuminate below the terminal. If supply is connected properly
a green LED will illuminate. See 120VAC wiring section for
more options.
Figure 13 -Incoming Power on 1050 Board
Main DC Power
+ –
SOLAR
PANEL
BATTERY
MAIN DC
POWER