IMPORTANT
This procedure can be performed on any single motor electric slideout.
1. Disconnect the red and black wires connected to the motor.
2. Using the the wires attached to the motor, connect to a 12 volt cordless battery to retract the slideout. If the
wire polarity is reversed, the slideout will extend instead of retract.
IMPORTANT
If the slideout motor has a brake installed, you must also hook one brake wire to the battery with the red
slideout motor wire and one with the black slideout motor wire.
1. Disconnect the wire(s) from the cordless battery pack.
PROCEDURE 2
Determine which slideout setup your coach utilizes, and follow the steps below pertaining to your specific setup.
CONVENTIONAL BEDROOM SLIDEOUT SETUP
IMPORTANT
This procedure can be performed on coaches with a slideout motor located under the bed frame.
This method is the fastest one if the motor or gears fail, as it does not require
battery power. However, this method requires a significant amount of manpower to
push in the slideout.
1. Open the lid of the bed box.
2. Loosen the trantorque bushing.
3. Push the room into the retracted position.
4. Retighten the trantorque bushing.
5. Take the coach to an authorized service center for diagnosis and repair.
-or-
1. Open the lid of the bed box.
2. Loosen the trantorque bushing.
3. Turn the shaft with a wrench until the slideout reaches the retracted
position. Make sure you do not damage the shaft with the wrench.
4. Retighten the trantorque bushing.
5. Take the coach to an authorized service center for diagnosis and repair.
© 2018 Copyright Newmar Corporation. All rights reserved. For the most up-to-date version of this content, and for more product-specific information, please refer to Newgle.
130