
6. Open the black water dump valve, and turn on the macerator pump switch.
7. Monitor the tank as it empties. The pump with run louder when the tank is empty.
8. Turn off the pump switch once the tank is empty.
9. Flush the black tank, and operate the macerator while it is flushing.
10. Turn off the flush system, then turn off the macerator.
11. Close the black water dump valve.
12. Add tank chemicals and the amount of water recommended by the chemical manufacturer.
13. Drain the gray tank next to help flush out the macerator and sewer hose.
HOW TO DRAIN THE GRAY WATER TANK
1. Open the gray water dump valve.
2. Turn on the pump switch.
3. Monitor the tank as it empties. The pump will run louder when the tank is empty.
4. Turn off the pump switch once the tank is empty.
5. Close the gray water dump valve.
6. Place the cap on the hose and store it.
7. Add tank chemicals and the amount of water recommended by the chemical manufacturer.
HOLDING TANK RINSE - NO FUSS FLUSH
This unit may be equipped with a flushing system for the
holding tanks. When draining your sewer tank, attach a
water hose to the sewer spray hookup. After the tank is
drained, leave the gate valve open, and open the water
valve to allow water to spray inside the sewage tank. Allow
the water to rinse the tank for a minimum of three to
five minutes to ensure it is clean. This should flush the inside of the tank of any debris that may be left inside.
Next, disconnect the freshwater hose and close the gate valve. If there are any solids still left inside the tank, fill the
sewage tank with approximately ten gallons of water through the stool. As you travel, the agitation of the water should
help liquefy any solids left in the tank. You can dump the sewage tank again at your next destination.
IMPORTANT
Always drain the sewage tank prior to rinsing. Never rinse a sewage tank that is full. The sewage drain must
be open while rinsing the sewage tank, and the drain hose must be positioned to drain into an approved
sewage dump station. Failure to open the valve will cause the sewage tank to fill with water, and can cause
damage to your plumbing and interior.
© 2018 Copyright Newmar Corporation. All rights reserved. For the most up-to-date version of this content, and for more product-specific information, please refer to Newgle.
124