© 2020 Copyright Newmar Corporation. All rights reserved. For the most up-to-date version of this content, and for more product-specific information, please refer to Newgle.
93
ELECTRONICS
CAMERA PRIORITY
•
Camera priority means that the system has certain
views that will override other views.
•
Pressing a manual button has priority over everything.
•
If you are in reverse and decide you want to go to
a di
ff
erent view, press a button and the view will
change to the selected view. That view now becomes
the “DEFAULT.”
•
If a turn signal is active and the coach is put into
reverse, the reverse command will override the turn
signal command.
DEFAULT CAMERA
If a camera button has been pressed, that view will
become “DEFAULT.” If a trigger is activated (like a turn
signal or reverse), the system will return to the “DEFAULT”
camera view when that trigger is deactivated.
WHEN FIRST STARTING THE ENGINE
The camera monitor should display the REAR NORMAL
view when first starting the engine.
Dynamic Parking Grid Lines
(DPGL)
Dynamic Parking Grid Lines (DPGL) are moving lines that
show you the
APPROXIMATE
path that the rear of the
coach will take depending on the turn of the steering
wheel. They use the information from the steering
angle sensor from the chassis ABS ECU to calculate the
trajectory of the turn.
1. The DPGL will only show up when the coach is in
reverse.
2. The DPGL can be seen on two views: REAR NORMAL
and 360 VIEW.
3. The DPGL can be tested by turning the wheel
completely in both directions.
6WDQGDUG'H´QLJK
'H´QLWLRQ&DPHUDV
The left turn, right turn, interior, trailer 1, and trailer 2 (if
equipped) cameras are standard definition cameras.
These are the only standard definition cameras in the
system. The rest of the views are from the HD Xite side of
the system.
Doorbell Camera Operation
The doorbell camera is only available in select coaches.
There are a few ways to access the Doorbell picture:
1. On the Xite radio, press the “Entry Cam” button on
the camera screen to view the picture on the camera
monitor.
2. If the doorbell button on the grab handle is pressed,
several things will happen:
•
All the displays (front overhead and bedroom
SilverLeaf monitor, and dash camera monitor) will
immediately switch to that camera, no matter what
was showing on the screen at the time the button
was pressed.
•
A 60-second timer is activated. The screens
will stay on the doorbell camera for one minute
and then revert back to the camera view prior
to doorbell activation. This time setting is
configurable.
•
Along with the camera switching when the doorbell
is pressed, the patio light is also activated in case
it is dark outside to allow you to see who is at the
door. If activated by the doorbell, the light will turn
o
ff
after 60 seconds.
•
If the patio light was already on when the doorbell
was pressed, it will remain on after 60 seconds.
When the coach is connected to the internet, MyRozie
is capable of sending a text message to your phone
that includes a still picture of the doorbell camera view.
Holding Tank Monitoring Systems
The monitor panel allows you to check the approximate levels in the fresh, gray, and black water holding
tanks, as well as propane levels (if equipped), and the battery condition. The monitor panel is generally
located in the front overhead cabinet, or above or near the entrance door. An additional monitor panel may
be located in the basement water compartment.
E
F
Summary of Contents for London Aire 2021
Page 1: ...2021 sm...
