NewMar London Aire 2021, Owner'S Manual

Page: 149 / 204

© 2020 Copyright Newmar Corporation. All rights reserved. For the most up-to-date version of this content, and for more product-specific information, please refer to Newgle.
144
HVAC
This article provides an overview for radiant heating (floor heat). The floor heat uses a heat mat placed
between the tile and the floor structure. A controller regulates the temperature and the timed heat cycles
depending on the controls set up for your system. The floor heat operates on 120 volt AC power.
Radiant Heating
If your coach is equipped with the SilverLeaf coach management system, refer to the SilverLeaf functional guide for more
information about the function and operation of the floor heat via the SilverLeaf touchscreen.
The Floor Heat screen displays and controls the
settings and schedules for floor heat. The floor heat
control system operates by switching the di ff erent floor
zone heat mats ON and OFF, as determined by the
intervals and values selected.
The approximate operating times are as follows based on
20 minute cycle:
•
One bar: Floor Heat O ff
•
Two bars: Store mode (Floor Heat will not operate in
this mode)
•
Three bars: On ~2 minutes (“O ff time” Remainder of
20 min. cycle)
•
Four bars: On ~4 minutes (“O ff time” Remainder of 20
min. cycle)
•
Five bars: On ~6 minutes (“O ff time” Remainder of 20
min. cycle)
•
Six bars: On ~8 minutes (“O ff time” Remainder of 20
min. cycle)
•
Seven bars: On ~10 minutes (“O ff time” Remainder of
20 min. cycle)
•
Eight bars: On ~12 minutes (“O ff time” Remainder of
20 min. cycle)
•
Nine bars: On ~14 minutes (“O ff time” Remainder of
20 min. cycle)
•
Ten bars: On ~16 minutes (“O ff time” Remainder of 20
min. cycle)
•
Eleven bars: On ~18 minutes (“O ff time” Remainder of
20 min. cycle)
•
Twelve bars: Heat mat is activated (constantly on)
Floor Heat via SilverLeaf
The floor heat zone settings are controlled by slider
bars. Use your finger to drag the slider bar or use the
up/down arrows on the touchscreen display to select
your preferred time. The higher the number of bars
selected, the longer the heat mat remains ON. An icon
will appear above the down arrow for each zone when
that particular zone is active (turned ON).