© 2020 Copyright Newmar Corporation. All rights reserved. For the most up-to-date version of this content, and for more product-specific information, please refer to Newgle.
133
EXTERIOR
TO OPEN THE EMERGENCY EXIT
DOUBLE LATCH STYLE WINDOW:
1. Unclip and lower the arm.
2. Swing the arm 90 degrees, and push out on the arm
until the red handle latches.
TO CLOSE AND LATCH THE
EMERGENCY EXIT DOUBLE LATCH
STYLE WINDOW:
1. Pull the window shut while holding the window track
with one hand.
2. With the other hand, rotate the latch up until it
connects with the track on the window.
3. Press the front side down until it latches.
4. Repeat the steps for the second latch.
Hehr Double-Latched
Emergency Exit Window
IN THE EVENT OF AN EMERGENCY,
OPEN THE WINDOW:
1. Remove the screen by pulling out on the red handle.
2. Push and release the lever from the locking hook.
3. Rotate the lever 90 degrees, and push it through the
slot in the window frame.
4. Escape through the opening.
This article provides an operational overview of a vented crank-style window.
How to Operate a Vented Crank-Style Window
Opening and Closing The Vent
To open a vented crank-style window, rotate the window
knob clockwise until the window reaches the fully-
extended position. The operator arms near the bottom will
be nearly straight when the window is fully extended.
To close a vented crank-style window, rotate the window
knob counterclockwise until the window is closed and the
knob can no longer be turned. The operator arms near
the bottom should also be snug.
Removing The Screen
To clean the inside of the window
and the screen, the screen must
be removed.
1. Remove the crank knob using
a Philips screwdriver in a
counterclockwise motion.
2. Carefully pull on the screen
frame until the clips pop out
from the window opening.
3. Clean the screen and inside
of the window.
4. Carefully pop the screen
back into the window frame.
5. Reinstall the crank knob
using a Philips screwdriver.
Hold the crank knob while
tightening the screw in a
clockwise motion.
This article provides the Newmar-recommended step-by-step instructions for operating the driver side power window.
How To Operate The Driver Side Power Window
The
Driver Side Window Directional Switch
on the dash operates the driver side window.
1. With the ignition on, press and hold the switch in the up or down position to move the window in the
desired direction.
2. Continue holding the switch until the desired window position is obtained. Then release the switch.
3. Pressing up on the switch closes the window, and pressing down on the switch opens the window.
Summary of Contents for London Aire 2021
Page 1: ...2021 sm...