© 2021 Copyright Newmar Corporation. All rights reserved. For the most up-to-date version of this content, and for more product-specific information, please refer to Newgle.
83
ELECTRONICS
Automatic Learn Feature and
Resetting The Panel To Default
The Digital Monitor Panel has two automatic learn features
and it will learn if the water and waste tanks have 1/3 or
1/4 increment sensors and if the LP sensor exists. Each
feature is learned independently, even for the individual
tanks. Once a feature is learned, it is stored in non-
volatile memory, and remembered even if battery power
is removed from the panel. The Digital Monitor Panel has
many safe guards to prevent improperly learning a feature.
Should the panel learn something incorrectly, an option
exists on the panel to reset the original factory default, so
that the panel can re-learn the proper features.
GENERATOR SCREEN
The display will show the
status of the generator:
•
Running
•
Stopped
•
Hour Meter (if installed by the OEM)
Tank Sensor and Calibration
The tank sensor features field effect
technology, a non-invasive method.
Each sensor array contains three
sensors which glue externally to the
polymer tank wall with high-grade,
long-life adhesive, at the position
and level that the water is to be
sensed, thus eliminating the need
for calibration.
Each sensor emits an electric field into the tank. When the
water level passes by the sensor, it detects a change in its
electric field.
The generator screen is only available on select coach
models and years.
NOTE FROM NEWMAR
TANK LEVELS SCREEN
1. Touch the “Levels Check”
button as many times
as needed to get to the
Tank Levels screen.
Monitor Panel Calibration
The monitor panel has been calibrated for accuracy
prior to leaving the factory and should not need to be
adjusted. In the event that the system does not read
accurately, then re-calibration may be necessary. Follow
the manufacturer’s procedures for re-calibration for your
specific product. It is recommended to have a qualified
service technician perform the re-calibration procedure.
Performing A Levels Check
For coaches not equipped with the SilverLeaf system,
simply press the “Levels Check” button to check the tank
level statuses. The levels will show on the digital display.
VOLTAGE SCREEN
2. Press and hold the
“Levels Check” button
for approximately six
seconds. The Voltages
screen appears right away, but continue holding the
button.
FACTORY MODE SCREEN
3. Once Factory Mode
screen appears, release
the “Levels Check”
button, and quickly press
and release again.
FACTORY RESET SCREEN
4. If done properly, the
Factory Reset screen
should appear. Factory
Default settings have
been reset, and the panel will go through the power-
up screen. If not, go back to step one, and repeat the
process.
The navigation feature is intended to assist you with
guidance to your destination. The system may need
software and map updates. Updates are not warrantable
issues, as roadways change over time and construction
takes place, the maps and/or systems may become
obsolete.
Your coach may be equipped with a GPS based Navigation system. This system uses GPS technology to
guide you through maps and information for traveling assistance. It features voice prompts and touchscreen
technology to make scrolling through the menus and getting information incredibly easy.
Navigation System
CAUTION
!
It is the driver’s responsibility to make sure the roads
are safe and appropriately navigated and roadway
weight limits and clearances are rated for the vehicle
you are driving.
Summary of Contents for Bay Star 2022
Page 1: ...SM 2022...
