© 20201Copyright Newmar Corporation. All rights reserved. For the most up-to-date version of this content, and for more product-specific information, please refer to Newgle.
46
CHASSIS
POWER OFF
Press and release the Power keypad button.
EQ Smart-Level
Coaches in production after 5/17/2019 may be equipped
with Smart-Level. Control the Equalizer leveling system via
your smartphone! To download Equalizer’s smartphone
app, open up the iTunes or Android Play Store and type in
“EQ Smart Level.”
Visually confirm all jacks are retracted prior to travel.
IMPORTANT
!
FEATURES
The Smart-Level has built in Bluetooth capabilities.
Compatible with iPhone, Android, and ASA Electronics iN-
Command Control System.
Manual Operation
POWER ON
Press and release the POWER keypad button to engage
power. All LED’s will come on then most will go out. The
LED next to the POWER button should be lit RED when
power is on.
EXTENDING JACKS MANUALLY
To extend the jacks the ignition key must be in the engine
run or on position and the park brake must be applied.
If you attempt to extend or retract jacks by pressing the
DOWN▼ or UP▲ keypad buttons you will hear a “deny”
tone from the keypad if the ignition key and or park brake
is in the improper position.
PLANTING THE JACKS
The jacks will be extended in pairs Fronts or Rears or
Left or Right Using the DOWN▼ (extend) keypad buttons,
extend the jacks until they contact the ground (this is
referred to as “planting” the jacks). As you extend each pair
of jacks the corresponding LED jack status lights will come
on to indicate jack(s) are out of the “stowed” position.
Extend and plant the front jacks first. Then extend and
plant the rear jacks. Only after planting the fronts and
then the rears, should side to side corrections (leveling)
be attempted. This process will stabilize all four corners
and minimize twist prior to the leveling process.
Jacks will be operated in pairs.
NOTICE
!
Do not manually over extend jacks. This may cause
unwanted stress on the coach or the jacks.
WARNING
!
The jacks down LED’s will turn off, indicating the jacks are
in the “stowed” position.
The keypad may be left on once level has been
achieved. The keypad will enter ‘sleep mode’ after
five minutes of inactivity.
NOTICE
!
RETRACTING THE JACKS
If your coach is equipped with air suspension, it is
recommended that the coach be started and chassis
air pressure allowed to build before pressing ALL
RETRACT. This will ensure adequate air supply to the
chassis air valves.
NOTICE
!
LEVELING THE COACH
Use a bubble level on a flat surface in the center of the
coach as a reference. Level the vehicle by using DOWN▼
(extend) or UP▲ (retract) keypad buttons until the vehicle is
level. Front to rear then side to side.
Do not attempt to lift the vehicle tires off of the
ground. Only lift (extend) enough to level and
stabilize the unit.
WARNING
!
Once level, press and release the POWER button to turn off
the keypad.
To retract the jacks the key must be in the engine run or on
position and the park brake must be applied. To retract all
jacks simultaneously, press and release the ALL RETRACT
button. All jacks will automatically retract and return to
stowed position. The pump will run in retract mode until all
of the jacks are fully stowed (plus an additional 5 seconds-
up to a maximum of 60 or 90 seconds). This is the proper
method for retracting the jacks prior to travel.
You may stop the ALL RETRACT by pressing any button
on the keypad. Jacks may be retracted in pairs by using
the UP▲ button for each end or side for leveling purposes.
However, the ALL RETRACT must be used to fully stow the
jacks prior to travel. The jacks down status LED lights will
turn off, indicating the jacks are in the stowed position.
Summary of Contents for Bay Star 2022
Page 1: ...SM 2022...
