NTI SERIMUX SERIES SSH CONSOLE SWITCH
74
Appendix D- Common Commands from Shell Command Line
To use the commands in this table, the user “root” must be logged in to the SERIMUX shell as described in page 10.
Command to Enter
Purpose
serimuxconfig
Open Configuration Menu
portmenu
Open Port Connect menu
facdefault
Restore Factory Default
Be Careful!
This command restores all factory default settings,
deleting any configuration settings that have been setup by the
user.
serconfsave
Configuration Save (Store the configuration to flash)
This will store your current configuration to on-board flash memory.
This would be good to use once all initial configuration of the
SERIMUX is complete.
serconfrestore
Configuration Restore (Restore configuration from flash)
This will restore your configuration from on-board flash memory,
overwriting any configuration settings you presently have.
Note: If the command “serconfrestore” is used without first having previously saved a configuration using
“serconfsave”, then factory default settings will be restored instead (same result provided by using “facdefault”
command)
Appendix E- SERIMUX-S-x Default Paths
Path
Purpose
/var/log/messages
System Log
/var/run/databuf/ttyXRxx.data
Port data buffering
/mnt/nfs
Mount for NFS
/mnt/src
Mount for USB
/usr1/conf.tar.gz
SERIMUX Complete Configuration file (password is encrypted)
Appendix F- SERIMUX-S-x Default Network Settings
Setting
Purpose
192.168.1.91
IP address
255.255.255.0
Subnet Mask
192.168.1.1
Default Gateway
Ethernet Pinouts
The SERIMUX with RJ45 connectors uses a standard Ethernet connector that is a shielded and compliant with AT&T 258
specifications.
Pin
Description
1 Tx+
2 Tx-
3 Rx+
4 NC
5 NC
6 Rx-
7 NC
8 NC
