All AirCheck G2 Settings
103
Network-defined test targets are already set up on the
AirCheck G2. Below are the network-defined test targets that
are shown on the
Test Targets
screen:
Default Gateway
DHCP Server
Primary DNS
Secondary DNS
AirCheck G2 uses these test targets to perform ICMP Ping
tests. Each test target, whether network-defined or user-
defined, is shown with a check-box that allows you to select it
to use during connection tests. By default, all network-
defined test targets are selected when the
Test Targets
screen opens. You can deselect any of them by un-checking
the corresponding box.
How to: Add a User-Defined Test Target
In
, the user-definable test targets are
www.google.com and www.netscout.com. The Google ping
test is included by default, and a ping test to NETSCOUT has
been added. You can add up to 10 user-defined test targets
with the following procedures:
1
Select
Add Test Target
to open the
Configure Target
screen.
2
On the Configure Target screen, select
Target
to open the
Test Target
screen.
3
Enter the IP address or host name of the test target, and
select
DONE
.
4
Next, touch the down arrow
to select a desired
Test Type.
NOTE:
The default test type is
ICMP Ping
. If you select
TCP Port Open
, then you must select
Port
to open the
TCP Port screen, specify the TCP port number, and then,
touch
DONE
. This will take you back to the Configure
Target screen.
5
Select
Apply
to implement the addition of the test target.
6
Repeat steps 1 through 5 to add up to 10 test targets.
7
When you have finished adding test targets, select
Apply
at the bottom of the Test Targets screen.
NOTE:
You can also edit and delete test targets using the
(Edit)
or
(Delete)
icons.
How to: Edit a user-defined Test Target
1
Select
(Edit)
.
2
Make the desired changes.
3
Select
Apply
.
How to: Delete a user-defined Test Target
1
Select
(Delete)
.
2
Select Yes in the pop-up confirmation message window.
