Using AutoTest to Diagnose Your Network Health
40
Figure 22. AutoTest Settings Screen
3
Touch
AutoTest
from the Home Screen.
Once the SSID and security credentials have been entered,
AutoTest runs
Network Tests
for each network selected.
In the example shown in
, security for the SSID,
“Cisco4400,” has been configured and added to the Profile,
and the network is selected in AutoTest Settings.
Network Test results are reported on the
AutoTest
results
screen below the
Air Quality
test results. In
Network test for “Cisco4400” has run and passed.
Figure 23. AutoTest Network Tests
NOTE:
When you connect to a network, the Tester usually
connects through the access point that has the highest
Signal-to-Noise Ratio. If the network includes secure and
unsecured access points and security credentials are
available, the Tester tries to connect to the secure access
point that has the highest Signal-to-Noise Ratio. Some
networks use a controller that connects you to the access
point that has the least amount of traffic.
