(Netgear Switch) (Interface 1/0/15)#exit
(Netgear Switch) (Config)#exit
(Netgear Switch) #show ip route
Total Number of Routes......................... 6
Network Subnet Next Hop Next Hop
Address Mask Protocol Intf IP Address
--------------- --------------- ------------ --------- ---------------
0.0.0.0 0.0.0.0 OSPF Inter 1/0/15 192.168.20.1
192.168.20.0 255.255.255.0 Local 1/0/15 192.168.20.2
192.168.30.0 255.255.255.0 Local 1/0/11 192.168.30.1
192.168.40.0 255.255.255.0 RIP 1/0/11 192.168.30.2
192.168.41.0 255.255.255.0 RIP 1/0/11 192.168.30.2
192.168.42.0 255.255.255.0 RIP 1/0/11 192.168.30.2
ProSafe 7000 Managed Switch Software Administration Manual, Release 8.0.3
OSPF
6-31
v1.0, June 2010
Web Interface: Configuring Area 1 as a nssa Area on A2
To use the Web interface to configure OSPF on the switch, proceed as follows:
1.
Enable IP routing on the switch:
a.
From the main menu, select Routing > IP > IP Configuration. A screen similar to the following
displays.
Figure
6-37
b.
Next to the Routing Mode, select the
Enable
radio button.
c.
Click
Apply
to save the settings.
2.
Assign IP address 192.168.30.1 to the port 1/0/11:
a.
From the main menu, select Routing > IP > Advanced> IP Interface Configuration. A screen
similar to the following displays.
