128
|
Chapter 7. Advanced Settings (Part 1)
N300 Wireless Dual Band ADSL2+ Modem Router DGND3300v2 User Manual
Figure 68.
3.
Select the
Enable Wireless Repeating Function
check box and the
Wireless Base
Station
radio button.
4.
Enter the MAC address for the repeater units.
5.
Click
Apply
to save your changes.
Setting Up a Repeater Unit
Use a wired Ethernet connection to set up the repeater unit to avoid conflicts with the wireless
connection to the base station.
Note:
If you are using the N300 Wireless Dual Band ADSL2+ Modem
Router DGND3300v2 base station with a non-NETGEAR N300
wireless modem router as the repeater, you might need to change
additional configuration settings. In particular, you should disable the
DHCP server function on the wireless repeater
AP.
To configure a N300 wireless modem router as a repeater unit:
1.
If you are using the same model of N300 wireless modem router for both the base
station and repeaters, you must change the LAN IP address for each repeater to a
different IP address in the same subnet (see
Using the LAN Setup Options
on
page
112).
Note:
Failing to change the LAN IP address will cause an IP address
conflict in the network because the factory default LAN IP is the
same for both units.
