126
|
Chapter 7. Advanced Settings (Part 1)
N300 Wireless Dual Band ADSL2+ Modem Router DGND3300v2 User Manual
The following figure shows a wireless repeating scenario:
Figure 66.
To set up a wireless network using WDS,
t
he following conditions must be met for both APs:
•
Both APs must use the same SSID, wireless channel, and encryption mode (see
Manually Configuring Your Wireless Settings
on page
18
or
Using Push 'N' Connect
(WPS) to Configure Your Wireless Network
on page
24).
•
Both APs must be on the same LAN IP subnet. That is, all the AP LAN IP addresses are
in the same network.
•
All LAN devices (wired and wireless computers) must be configured to operate in the
same LAN network address range as the APs.
•
When the N300 wireless modem router is in dual band mode (the Mode field on the
Wireless Settings screen is set to Up to 300 Mbps at 5 GHz and 54 Mbps at 2.4 GHz), the
WDS function works only in 5 GHz 11N mode. To use the 2.4 GHz 11g protocol with
WDS, set the Mode field in the Wireless Settings screen to Up to 300 Mbps at 2.4 GHz. If
you make changes in the Wireless Settings screen, click
Apply
so that they take effect.
Wireless Repeating Function
You can view or change wireless repeater settings for the N300 wireless modem router. From
the main menu of the browser interface, under Advanced, click
Wireless Repeating Function
to display the Wireless Repeating Function screen.
Repeater AP
Base Station AP
