Neptune 13458-000, Installation And Maintenance Manual

Page: 58 / 150

Attaching the Power Cable
Figure 48 – Power Cable
Attach the power plug to the Gateway by pushing and rotating
the circular power connector clockwise to engage it.
Do not weatherize the power connection. The power
connector is IP68-rated and does not require weatherization
wrap.
The protective cover (CONEC P/N: 17-10002) should
always cover the Ethernet port when the port is not in
use. See Figure 48.
Securing the Gateway
Secure the Gateway cover with the tamper-resistant T27 Torx
Pin-Head tool.
Applying the Ballast to the Stand
Install a roof pad between the stand and rooftop to
protect the roof. See "Ballast Requirements" on page 99
of Appendix B.
Apply ballast according to applicable local code
requirements. The installation must meet all applicable
local, state, and federal requirements.
The stand and antenna mast must be grounded
according to applicable NEC, CEC, and local codes.
Refer to NEC Article 810 and CEC Section 54.
40 R900 Gateway Installation and Maintenance Guide
Chapter 4: Installation of the Gateway