![background image](http://html.mh-extra.com/html/nec/powermate-professional-9000e-service/powermate-professional-9000e-service_service-manual_248711111.webp)
4-20 System Board
System Board Jumpers
The figure on the following page shows the location of jumper blocks on the
system board. To reconfigure jumper block, see the following paragraphs. (The
factory-set jumper settings are included in Section 2, “System Configuration.”)
Locating System Board Jumpers
A - BMC Forced Update Mode B - Chassis Intrusion Detection
C - FRB Timer Enable D - Boot Block Write Protect
E - Recovery Boot F - Password Clear G - CMOS Clear
H - Reserved I - Reserved
Moving System Board Jumpers
!
WARNING
Before doing the procedures in this section, make sure that
your system is powered off and the AC power cord is
unplugged from the back of the chassis. Failure to
disconnect power before moving the jumpers can result in
personal injury and equipment damage.
Observe static precautions. Use an antistatic wrist strap.
To configure the system board options:
1.
Power off the system and remove the left panel as described in Section 3 of
this manual.
Summary of Contents for POWERMATE PROFESSIONAL 9000E - SERVICE
