4-12 Installing Options
Removing an Expansion Board
To remove an expansion board, use the following steps.
1.
Remove the cover (see “Removing the Cover” earlier in this chapter).
2.
Label and unplug any cables connected to the board.
3.
Remove the retainer bar (see “Removing the Retainer Bar”).
4.
Hold the expansion board by its edges or its bracket and pull it out of
the connector and expansion slot. Set the board on an antistatic
surface.
Disconnecting an expansion board
A – Expansion Board
5.
Install a new board, or install the slot cover if you are not installing a
board.
!
If you are adding an expansion board, see “Installing an
Expansion Board.”
!
If you need to install a slot cover, see “Installing a Slot Cover.”
