4-34 Installing Options
2.
Position the cover so the arrows on either side point up for the chassis
orientation you are using.
3.
Line up the cover tabs with the slots on the rails. These slots are
about 1/4 inch in from the ends of the rails (see the following figure).
4.
Place each cover tab in its slot.
Positioning a Bay Cover*
A – Slot on Rail
C – Bay Cover
B – Tab on Bay Cover
* Rails are shown partially out of the system in this figure to show in detail the
tabs at the end of each rail; make sure rails are fully inserted before attaching a
bay cover.
Storing and Retrieving Unused Rails
The device rails on the 5 1/4-inch devices in your system are designed
specially for the chassis. If your system has an unused 5 1/4-inch bay,
there should be rails stored within it. Use these rails on new devices (if
necessary). If you remove an old device, remove the rails and store them.
If there is an empty 5 1/4-inch bay, store the rails in the chassis; otherwise
set the rails aside for future use.
To store a rail in an empty bay:
!
Position the end of the rail in the guides within the bay. The underside
of the rail should be to the wall of the bay. The tab should be angled
away from the center of the bay. See the following figure.
