4-42 Installing Options
8.
If you are installing another 3 1/2-inch accessible device, see
“Installing a 3 1/2-Inch Accessible Device.” If you are not installing a
new device at this time, continue with step 9.
9.
Press the plastic bay cover over the opening in the bracket cover.
10.
Press the bracket cover over the front shield so the two side tabs click
into place.
11.
Slide the bracket into the chassis. The tab at either side of the bracket
should click into place.
12.
If there is still a device in the other bay of the bracket, reconnect its
power and signal cables (see “Diskette Drive Cabling”).
13.
Replace the front panel (see “Replacing the Front Panel”).
14.
Replace the system unit cover (see “Replacing the Cover”).
Installing a 3 1/2-Inch Accessible Device
Install a new device in the bracket, and then install the bracket in the
system.
Before removing the cover, turn off system
power and unplug the system power cable. Power is removed only when
the power cable is unplugged.
1.
Follow the instructions in steps 1 to 8 in the previous section,
“Removing a 3 1/2-Inch Accessible Device,” to remove the two-
device bracket and (if applicable) the old device from the system.
2.
If you are installing the device in an empty bay, uncover the bay:
!
remove the 3 1/2-inch plastic bay cover from the bracket cover
by pressing its tabs together while pushing it out of its opening
!
remove the breakaway shield (if any) from the front shield by
twisting it gently until it comes off.
3.
Slide the new device into the front of the bracket, connector end first.
4.
Secure the new device to the bracket with four screws, two to a side
(see the figure “The 3 1/2-inch accessible device bracket” in the
previous section).
