![background image](http://html.mh-extra.com/html/nec/powermate-5100-service/powermate-5100-service_service-manual_248650031.webp)
2-4 System Configuration
Serial Port Interrupts
The interrupts for serial port 1 and serial port 2 are given in the following table.
Any interrupts used for the built-in serial ports are not available for ISA parallel
ports. Also, if serial ports share an interrupt, verify that hardware and software
added to the system can share these interrupts without problems.
Serial Port 1 and Serial Port 2 Interrupts
Port
Interrupt
COM1
IRQ04
COM2
IRQ03
COM3
IRQ04
COM4
IRQ03
COM1
IRQ03
COM2
IRQ04
COM3
IRQ03
COM4
IRQ04
Jumper Settings
Jumpers on the boards and devices in the system are used to set the system
configuration. Boards and devices using jumpers include:
system board
riser board
IDE hard drives
CD-ROM drives
fax/modem board.
The following paragraphs list the jumpers and their factory settings.
Note: Jumpers are set correctly at the factory for the
system configuration. If a jumper change is required, change
only the setting for that condition (see Section 4 and
Section 5 for procedures on setting jumpers).
Summary of Contents for POWERMATE 5100 - SERVICE
