NEC POWERMATE 5100 - SERVICE, Service Manual

Page: 44 / 237

System Configuration 2-17
IDE Device Configuration Parameters
Menu Item Settings and Description
Maximum Capacity Displays capacity in MB.
When Type is set to Auto, the value in the Maximum
Capacity field is computed from the auto-detected values in
Cylinders, Heads, and Sectors, and the field is read only.
Multi-Sector Transfers Disabled , 2 sectors, 4 sectors, 8 sectors,
16 sectors
When Type is set to Auto, the value in the Multi-Sector
Transfers field is auto-detected and the field is read only.
LBA Mode Control Disabled, Enabled
When Enabled is selected, it causes logical block
addressing to be used in place of cylinders, heads, and
sectors.
When Type is set to Auto, the value in the LBA Mode
Control field is auto-detected and the field is read only.
Transfer Mode Standard
Fast PIO Mode 1
Fast PIO Mode 2
Fast PIO Mode 3
Fast PIO Mode 4
FPIO3 & Bus Mastering
FPIO4 & Bus Mastering
When Type is set to Auto, the value in the Transfer Mode
field is auto-detected and the field is read only.
Ultra DMA Disabled, Mode 0, Mode 1, Mode 2
When Type is set to Auto, the value in the Ultra DMA field is
auto-detected and the field is read only.
Floppy Options
This menu configures the floppy (diskette) drive device whenever it is removed
or its settings need to be changed. Use the fields in the following table to
configure the system when making any diskette drive changes.
Floppy Drive Options
Menu Item Settings and Descriptions
Floppy Disk Controller Enabled (default), Disabled.
This field enables the diskette drive interface connector on
the riser board.
Diskette A: Disabled, 360 KB 5 1/4”, 1.2 MB 5 1/4”, 720 KB 3 1/2”,
1.44/1.25 MB 3 1/2” (default), 2.88 MB 3 1/2”.
Floppy Write Protect Disabled (default), Enabled.
Set the field to Enabled to write-protect diskettes.