![background image](http://html.mh-extra.com/html/nec/powermate-5100-service/powermate-5100-service_service-manual_248650105.webp)
Disassembly and Reassembly 3-19
5.
Slide the riser board to the right to remove the RJ-45 connector from the
LAN slot in the rear of the chassis.
6.
Lift the riser board out of the system unit.
CMOS Battery Removal
Remove the 3-volt lithium battery from the system board as follows.
1.
Turn off and unplug the system unit and any external options connected to
the system.
!
CAUTION
Removing the battery from the system board causes the
computer to lose system configuration information. If
possible, run Setup and record the system configuration
settings before removing the battery. Use that information to
restore the system after replacing the battery.
2.
Locate the battery and its socket on the system board (see the following
figure).
Locating the Battery
A – Battery
Summary of Contents for POWERMATE 5100 - SERVICE
