4-44 Disassembly and Reassembly
Removing the Side Panel Intrusion and
Interlock Switch Assemblies
Note:
The side panel intrusion and interlock switch
assemblies consist of a switch with a cable and a single
cable connector.
1.
Power off the system and remove the left and right side panels as described
earlier in this chapter.
2.
If removing the left side panel "Intrusion Switch Assembly", tag and
disconnect the intrusion switch cable from the SCSI backplane connector J5
(pins 1 and 2).
3.
If removing the right side panel "Interlock Switch Assembly", tag and
disconnect the interlock switch cable from the power board connector J13
(pins 1 and 2).
4.
Remove the intrusion and interlock switches by releasing the two plastic
snap tabs securing the switch to its holder and sliding it forward until it is
free of the holder (see Figure below).
5.
Remove the Intrusion and Interlock Switch Assemblies.
Removing the Side Panel Intrusion and Interlock Switch Assemblies
Summary of Contents for NEAX Express
