NEC Express5800/120Ri-2, User Manual

Page: 269 / 349

9-44 Upgrading Your Server
Notes
Observe the following notes on installing/removing a PCI board:
Do not touch the terminals of the riser cards and the leads of electronic components with
your bare hand. Fingerprints and dust left on them cause the server to malfunction due to a
connection failure or damage to the leads.
A riser card is designed for installing only low-profile PCI boards or full-height PCI
boards. Before installing a PCI board, make sure of the card specification.
The mother board is not equipped with a connector for LED relay cable.
The system searches for the PCI board in the following order:
PCI Slot 3B
→
1B
→
2B
→
1C
→
3C
→
2C
When N8116-02 is installed:
PCI Slot 3B
→
2B
→
1B
→
1C
→
3C
→
2C
The PCI devices of the same type (including onboard PCI device) may be recognized in
different order from that described above, depending on OS or disk array BIOS utility.
Check the slot location of PCI device by PCI bus number, device number and function
number shown in the table below.
Bus number Device number Function number
Onboard NIC1 C 0 0
Onboard NIC2 C 0 1
Onboard SAS D 5 0
Slot 1C 18 0 X
Slot 2C 20 0 X
Slot 3C 1C 0 X
Slot 1B 0D * 3 X
Slot 2B 0D * 9 X
Slot 3B 3 * 0 X
* On certain PCI devices, other bus number may be assigned..
Set "Disabled" for the optional ROM of a LAN device not to be booted by using the BIOS
SETUP utility.
If an additional LAN device is installed in slot 3C or 3B, it is hard to push the catch of the
connector with your finger that is connected to the LAN port. Disconnect the connector
pushing the catch with a standard screwdriver. At this time, be very careful for the
screwdriver not to damage the LAN port or other ports.