![background image](http://html.mh-extra.com/html/nec/express5800-120mc2-series/express5800-120mc2-series_user-manual_251191094.webp)
4-22
Upgrading Your System
4.
Remove the hard disk drive from its carrier by removing the four screws.
See Figure "Securing the Drive in the Carrier."
5.
Remove the new drive from its protective wrapper, and place on an antistatic
surface.
!
CAUTION
Observe static precautions. Use an antistatic wrist strap.
6.
Record the drive model and serial numbers in the equipment log.
7.
Install the drive in the drive carrier. See Figure "Securing the Drive in the
Carrier."
!
Place the drive on the carrier, with its connector facing the back of the
carrier.
!
Turn the drive and carrier over and secure the drive in the carrier with the
four screws supplied with the disk drive.
Securing the Drive in the Carrier
8.
Install the drive carrier with drive into the bay (see Figure "Installing a Disk
Carrier into the Bay") as follows:
!
Open the drive carrier handle.
!
Align the drive carrier with the bay guide rails.
!
Slide the drive carrier into the bay until it docks with the SCSI backplane
connector.
!
Push on the carrier until the drive is completely seated into the SCSI
backplane connector, and the carrier handle is flush with the front of the
carrier.
!
Close the drive carrier handle.
Summary of Contents for Express5800/120Mc2 series
