![background image](http://html.mh-extra.com/html/nec/express5800-120mc2-series/express5800-120mc2-series_user-manual_251191093.webp)
Upgrading Your System 4-21
Installing or Swapping a Hard Disk Drive
1.
Open the front door as described earlier in this chapter.
2.
If installing a hard disk drive in a disk carrier for the first time, perform the
following procedures:
!
Pull the handle (A) out of the hard disk drive bay panel and remove it
from the SCSI hard disk drive bay.
Note:
The hard disk drive bay panel is no longer
needed.
Removing the Hard Disk Drive Bay Panel
!
Go to step 5.
3.
If swapping a hard disk drive, remove its carrier from the SCSI hard disk
drive bay by performing the following procedures:
!
CAUTION
Depending on the drive fault, the drive may be still spinning
when you remove it. Follow the next steps exactly when
removing drives.
!
Pull the hard disk drive carrier's handle out.
!
Pull the faulty disk drive out of the bay by its outside edges far enough to
disengage the drive connector from the backplane. Wait 30 seconds until
the drive spins down.
!
Remove the hard disk drive carrier from the drive bay.
Summary of Contents for Express5800/120Mc2 series
