NEC ElectraElite IPK, Programming Manual

Page: 502 / 803

Electra Elite IPK Document Revision 4
Programming Manual 2 - 425
___________________________________________________________________________________
___________________________________________________________________________________
3-00 Trunk Name/Number Assignment
General Description
Use this Memory Block to specify telephone name/number for the CO/PBX line that is
displayed when the CO/PBX Line is seized, or during an incoming call.
Display
Settings
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shaded
selection is the
default.
Number Name
Programming Procedures
1 Go off-line.
2 Press LK3 to access the Memory Block.
3 Leave Number set or press LK2 to change to name for the data option for the selected
CO/PBX No. 01, and enter the number or name (refer to Notes).
Use the following to enter data:
J
to move the cursor left
L
to move the cursor right
K
~
I
to enter numeric data or CO/PBX No.
– OR –
D
to go to the next assigned CO/PBX No.
B
to generate a - (hyphen)
H
to generate a space (clear after hold)
Default Values
Not Specified
4 Press
G
to write the data. The next Memory Block is displayed.
5 After Memory Blocks 3-02~3-70 are programmed, the next CO/PBX No. is displayed.
6 Repeat steps 3~5 for each CO/PBX No. After the last CO/PBX number is programmed, CO/PBX No. 01 is displayed again.
7 Press
E
to go back on-line.
CO/PBX Line Mode
3
Submode
—
Data No.
00
PC Programming
¦
+BCT
0 1 /
T I M E D I S P L A Y
CO/PBX No.
(01~64)
Setting Data
(13 digits maximum)