NEC ElectraElite IPK, Programming Manual

Page: 573 / 803

2 - 496 Memory Blocks
___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
___________________________________________________________________________________
3-77 ISDN-BRI/PRI Directory Number
Checking Selection
General Description
Use this Memory Block to determine whether or not the BRT/PRT ETU passes the
Directory Number to the CPU when it is received in the ISDN Set Up message.
Enhancement
R4000 or higher and BRT Firmware 2.05 or higher support DID for ISDN-BRI Trunks.
This allows BRI and DID callers with non-matching SPID Numbers to determine whether the
system checks the called party number with the SETUP message and the SPID setup. When this Memory Block is set to
NO, DID calls can be received on BRI trunks and directed according to Memory Block 1-1-22 (DID Digit Conversion
Table).
Display
Settings
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shaded
selection is the
default.
NO YES
Programming Procedures
1 Go off-line.
2 Press LK3 +
G
+
GG
to access the Memory Block.
Use the following to enter data:
J
to move the cursor left
L
to move the cursor right
K
~
I
to enter numeric data or CO/PBX No.
– OR –
D
to go to the next assigned CO/PBX No.
Default Values
CO/PBX No. 01~64
3 Press the corresponding CO/PBX line key to change the Setting Data option.
4 Press
G
to write the selected data and display next Memory Block.
5 Program the next Memory Block or press
E
to go back on-line.
CO/PBX Line Mode
3
Submode
—
Data No.
77
PC Programming
¦
+AN
0 1 / 7 7 : D N C H K N O
T I M E D I S P L A Y
CO/PBX
No.
(01~64)
Data
No.
Setting
Data
Title