NEC DTL-12BT-1 - DT330 - Plus BCH, Description, Page: 177 / 184

UNIVERGE SV8100 Issue 5.0
General Description Manual 5 - 27
6.3.5 Series i Terminals

The voltage and current for the D
term
Series i multiline terminals are
listed below:
Voltage: -11 ~ -48 Vdc
Maximum Current: 250 mA

Voltage, current, and ring signal information for Single Line Telephone
equipment, AP(A)-R Unit, and AP(R)-R Unit are the same a those listed
in the previous paragraph.
6.4 Dialing Specifications
6.4.1 Dial Pulse Address Signaling
Dial Pulse Address Signaling uses dial pulses (regular momentary
interruptions) to signal the equipment. The following Dial Pulse
specifications are used In the UNIVERGE SV8100 system.

Pulse Rate: 10 ± 0.5 pps/20 ± 1.0 pps

Percent Break: 60 ± 1.5%

Interdigit Interval: 0 pps/20 pps 770ms. ~ 830ms.
6.4.2 Dual-Tone Multifrequency (DTMF) Address Signaling
DTMF signaling includes push button or Touchtone dialing. When a
key on a telephone is pushed, two tones (one high frequency and
one low frequency) are provided. In the UNIVERGE SV8100 system,
the following DTMF specifications are used.

Frequencies
Two sinusoidal frequencies are provided, one from the high frequency
group and one from the low frequency group.

Frequency Deviation: Less than ±1.5%

Signal Level:
Nominal level per frequency: -6 ~ -4 dBm
Minimum level per frequency
Low Group: -10 dBm
High Group: -8 dBm
Maximum level per frequency: 0 dBm
Acoustical characteristics meet Electronic Industry
Association (EIA) standard proposal SP-1286 and
standard EIA RS-470.