Section 4: Telephones and Optional Equipment
Aspire S Hardware Manual
Section 4: Telephones and Optional Equipment
◆
4-5
4
9.
Install a modular jack for each 2PGDAD module. For each module, run one-pair 24 AWG station
cable from the cross-connect block to a modular jack. Ground the unused pair.
10. Terminate the extension leads to GRN/RED of the modular jack. Terminate the unused leads to the
jack.
11. Install bridging clips as required.
In order for the module to ID correctly, set the circuit type to “0” for the port in Program
10-03-01 prior to connecting the line cord.
12. Plug a modular line cord from the mod jack to the CN1 connector on the 2PGDAD module.
Important
In some cases, when testing the operation of an extension port when connecting to a Cordless II, Cordless
Lite II, or 2PGDAD module, a technician may connect a line cord directly from an extension port on the
Aspire/Aspire S ESIU PCB or Aspire S CPU. Though this is not the recommended connection, it can be
used to check if the extension has dial tone.
Should a direct connection of this type be made to the base station of the Cordless II or Cordless Lite II, or to
a 2PGDAD module, the line cord must be 2-wire (1-pair). If a 2-pair wire is used, the system will provide
power to the unused pair. This can prevent the cordless telephone from acquiring a link with the base station
or it can damage the 2PGDAD module or the Aspire station card.
The recommended connection is to punch down 2 wires to the cross-connect block, then connect the exten-
sion block to the RJ61 connector on the PCB or CPU.
1.
Optional:
To wall mount the 2PGDAD module, insert two wood screws 100mm apart (3 15/16”). Leave 3mm
(1/8”) of the screw exposed. The screws can be installed either vertical or horizontal, depending on
which position
fi
ts best for your location.
Figure 4-7: INSTALLING THE SCREWS
0893100 - 62
4mm
100mm
100mm
3mm
