Section 4: Optional Equipment
Aspila EX Hardware Manual
Section 4: Optional Equipment
4-29
4
CTU Adapter
(Figure 4-31 - Figure 4-32)
The CTU Adapter provides a USB connector. This can be used for either SMDR, TAPI (1.4), system
reporting, or PC Programming.
Installing the CTU Adapter:
1. Unplug the line cord from the system phone.
2. If only one adapter is to be installed on the phone, the adapter should be installed on the right-
hand side of the phone (beneath the handset). Using a flat-head screwdriver, remove the plas-
tic punch-out piece covering the connector.
3. Set the dip switches on the CTU adapter to the required position.
•
The DSW settings are 1 = on, 2-8 = off for a PC connection or 1 and 2 = on, 3-8 = off for a
printer connection (factory setting is for a PC connection).
Figure 4-31: RECORDING DIP SWITCH SETTINGS
4. Position the adapter with the connector positioned as shown below.
Figure 4-32: POSITIONING THE ADAPTER
5. Hook the two plastic prongs into the bottom of the phone.
6. Push the connector into place. The top latch on the top of the adapter should lock into place
when it is properly positioned.
7. Plug the line cord back into the system phone.
The USB cable connected to the CTU must pass two times through (one
turn) the ferrite sleeve supplied to comply with EMC requirements.
CÔNG TY VIỄN THÔNG VIỆT PRO
Chuyên phân phối tổng đài NEC
http://vietpro.com.vn
