Nautel VS1, Operation And Maintenance Manual, Page: 180 / 224

VS1 Operations and Maintenance Manual Operating the transmitter
Page 2-152 Issue 3.1 2013-10-01
Use the up and down buttons to select the desired digital input (1 through 10) from the list. Each
screen shows the current digital input parameter (e.g.,
RF On/Off
), as well as the polarity (e.g.,
Falling
edge RF On
) and current state (e.g., high, low) of the corresponding input pin. Use the right-arrow
button to enter the
Selection/Polarity
screen for the selected input to allow editing of the selection
or the polarity. Press cancel (
X
) to return to the previous menu.
If you save a change to a digital input via the front panel UI, it will also be displayed on the AUI page.
Digital Outputs - Front Panel
Using the
Remote Outputs
screens (see Figure 2.136 ), you can configure up to 16 digital outputs
that indicate either the presence of various alarms or the status of operator controlled circuits.
Nautel sets digital output defaults prior to shipping. See the VS1 Pre-installation Manual for details.
Figure 2.136: Remote Outputs Screens (Output 1 shown)
Note:
The selection and polarity options for digital inputs are the same as described in Select Input
Channel - AUI on page 2-145 and Configure Input control logic - AUI on page 2-146
.