© by N&W GLOBAL VENDING S.p.A.
23
05-2015 3625 01
sElECTIoN PRICEs
The machine can manage up to 4 different prices per
selection, which can be active according to the time
band you have set (standard or promotional) and/or the
payment system in use.
Use this function to vary the sales price for every single
selection by selecting among the price ranges available.
MaNagEMENT of ChaNgE TUbEs
This function is active only if this operation can be
carried out by the payment system you have set up.
Access the function to manually load or empty the
change tubes.
tubE
loaD
If you confirm loading,
“Credit : ——” will appear on the display. This is the value
of the money made available in the tubes for the change.
If you insert a coin into the validator, the display will
increase the value of the money made available in the
tubes for the change.
tubE
uNloaD
If you confirm unloading, you can establish the tube on
which you wish to act.
Whenever you press the Enter key
, a coin is ejected
by the active tube.
sPECIal sElECTIoNs
Set up the following parameters from this group of func
-
tions:
v
irtual
sElEctioNs
This function is used to define a pair of selections that
can be sold at a price different from the sum of the two
single selections, using one single selection number. 10
virtual selections can be programmed (from 70 to 79).
v
irtual
pricE
rEturN
Use this function if you do not wish to cash the price of
the second selection if the second dispensing cycle of
a virtual selection should fail (only if MDB payment sys
-
tems or validators are in use).
For the other payment systems, you can establish
whether to return the whole amount or not.
t
wo
-
motor
sElEctioNs
To dispense long products, you can mount the dividers
in order to use two motors for one single selection.
Use this function to combine the operation of two motors
by specifying the selection number and the second mo
-
tor.
The first motor number will be the selection number
whereas the selection number of the associated motor
will remain disabled.
Important !!!
after a failure to the motors of these selections, fol-
low the procedure intended to configure the “spi
-
rals/selections” menu of the machine.
D
ispENsiNg
cyclE
DEtEctioN
The machine can be fitted (as a standard or as an op
-
tion according to the models) with a device intended to
detect the passage of dispensed products by means of
photocells.
If no dispensing cycle is detected for a product, this
device will enable you to:
-
set a rotation time for the spiral beyond the limit switch,
to overcome any jam;
-
return the paid amount or not;
-
lock any further selection on the spiral in question.
