NAMCO Tekken Tag Tournament, Operation Manual

Page: 39 / 59

JVS CABINET OPTIONS
<DEFAULTS IN GREEN>
VIDEO SYNC: Composite
VIDEO STANDARD
[STEP
. . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . .
E X I T
: Pl -START
J
2
Hit the Pi S-direction joystick to right.
Display on the VIDEO
Each time it is hit, the synchronizing signal output type of the video output, which is displayed
under “VIDEO SYNC” (shown as (a) in the above figure), shall be switched to change the
setting. (The type shown in the thick frame below is the default setting.)
j o y s t i c k
Note: The above figure shows the pair control panel. In case of the single control panel
(that is, two cabinets corresponding to VIDEO standard are
linked for networked play), the control panel of the cabinet on which
the board is installed shall he called
Synchronizing signal output type of the video output
Composite S e p a r a t e
(composite synchronization)
(vertical synchronization)
l
When using the cabinet corresponding to the separate signal, set the ‘VIDEO
SYNC” as “Separate” for the best picture.
l
Namco-made cabinet corresponds to the separate signal. But if
another monitor display is connected to the line output picture terminal on the back
of the cabinet, set the
SYNC” as “Composite”, because that monitor
display may get poor picture under the “Separate” setting.
3 Press the start switch to return to the test menu screen.
PI start switch
Note: The above figure shows the pair control panel. In case of the single control panel
(that is, two cabinets corresponding to the VIDEO standard are
linked for networked play), the control panel of the cabinet on which
the PC board is installed shall called as PI.