1
the power switch of the cabinet
and unplug the power cord from an electrical outlet.
2
In cases that the control panel of your cabinet is different from the figure in the previous page,
replace the control panel or add/reduce button switches. If some switches are reduced, be sure
to fill up the switch holes with hole caps.
3
Check if each joystick and switch of the control pane1 is appropriately connected to each
control panel connecting terminal on the cabinet with reference to the figure in the previous
page and the operation manual of your cabinet.
C o n t r o l p a n e l c o n n e c t i n g t e r m i n a l
attached on the cabinet
l
In case the button switch is three-terminal, the input terminal (such as
of the control panel connecting terminal should be connected to the
N.O. terminal of the button switch. GND of the control panel connecting terminal
should be connected to the COM terminal of the button switch.
In case the button switch is two-terminal, these can be connected to either
terminal.
5-4-2 Connection of Cables
The power source on the cabinet connected to the power cable should fit the following requirements:
Voltage allowable error for
should be
Amperage should be
or more
If the power source does not conform to this requirement, it may cause a fire.
1
the power switch of the cabinet OFF and unplug the power cord from the electrical outlet.
Summary of Contents for Tekken Tag Tournament
Page 1: ......
Page 56: ...11 APPENDIX A Control Panel Layout Template Electrical Diagram 54...
Page 58: ...00 ti OG Z 00 0 66 0 6 1...
Page 59: ...3...