![background image](http://html2.mh-extra.com/html/namco/tekken-tag-tournament/tekken-tag-tournament_operation-manual_3189947016.webp)
2
Check the power source for the cabinet connecting to the
edge connector and voltage
of the power source for the coin counter of the cabinet.
WARNING :
l
The power source on the cabinet connected to the
edge connector should fit the following
requirements:
Voltage allowable error for
should be
Amperage should be
or more
Voltage allowable error for
should be
Amperage should be 2A or more
If the power source does not conform to this requirement, it may cause a
Voltage of the power source for the coin counter of the cabinet should be
or
If higher voltage is used, PC board may malfunction.
5-3-2 Checking the Extended Edge Connector
To connect this product to the cabinet corresponding to the
standard, use the extended
edge connector attached to this product.
Check if the terminal numbers of the extended edge connector conform to the following table.
*
The extended edge connector shall not be used when installing the product to the cabinet
corresponding to the
VIDEO standard (JVS).
l
Nothing should be connected to the blank parts of the table. Otherwise the PC
board may break down.
Extended Edge Connector
2.54 mm pitch)
PI button switch 4 (blue)
A 1 6
A 1 7
A 1 9
A 2 0
B 2 0
A 2 2
B 2 2
A 2 3
B 2 3
A 2 4
B 2 4
button switch 5 (purple)
Summary of Contents for Tekken Tag Tournament
Page 1: ......
Page 56: ...11 APPENDIX A Control Panel Layout Template Electrical Diagram 54...
Page 58: ...00 ti OG Z 00 0 66 0 6 1...
Page 59: ...3...